Units management

Units are managed with the GUnit class or more directly with GMetricUnit.

// To display a menu allowing to display kilometers (km) or Nautic Miles (nmi)
GUnit[] unitDis = { new GMetricUnit ("km") , new GMetricUnit ("nmi") };

Since V1.7, a statyic factory method is available to simplify the creation of such tabel. We may write:

GUnit[] unitDis = GUnitFactory.getGUnitArray("km", "nmi");

In case of using GMetricUnit, when we define a unit for a real value, it is stored automatically in the computer memory in International System (IS) (m, kg, rad …).

dist  = new GEntryReal("Distance", 1000., unitDis); // Initialization with 1000 meters.

Thus, in that case, we may have a difference between what it is displayed (for example 1.0 km) and what it is actually stored in the memory (1000.).

To get the value stored in memory (same for an integer even if there is no units for it), we will use the getValue() method:

double val = dist.getValue(); // Allways in IS

The basic IS units given by default by GENIUS are the following:

• kilogram (kg)
• meter (m)
• second (s)
• Amper (A)

Of course, GENIUS proposes also angular units with radian (rad) for IS to be convertible in degree (deg).

Then, it is possible to get composed units using "." for multiplication, "/" for division or "^'" for power (a negative power is enabled). Thus, we may have kg.m/s^2 (or kg.m.s^-2) as a composed unit.

Allways about composed units, GENIUS proposes the following ones:

• Steradians (m².m^-2) => sr
• Hertz (s^-1) => Hz
• Newton (kg.m.s^-2) => N
• Pascal (N.m^-2) => Pa
• Joules (N.m) => J
• Watt (J.s^-1) => W
• Coulomb (A.s) => C
• Volt (W.A^-1) => V
• Farad (C.V^-1) => F
• Ohm (V.A^-1) => R

For more facilities, these units have also been added:

• gramm = 0.001*kg => g
• ton = 1000 kg => t
• minutes = 60 s => mn
• hour = 3600 s => h
• day = 86400 => j

It is also possible to use coefficients:

• T: Tera = 10¹²
• G : Giga = 10⁹
• M: Mega = 10⁶
• k: kilo = 10³
• h: hecto = 10²
• da: deca = 10
• d: deci = 10^-1
• c: centi = 10^-2
• m: mili = 10^-3
• u: micro = 10^-6
• n: nano = 10^-9
• p: pico = 10^-12

Note that for mass values, these coefficient will be applied on "g" and not "kg".

So, we could have something as mg.dam/mn^2 ... for something equivalent as (1/36)10-6 Newtons !

At last, for not proportional conversions, GENIUS proposes anyway to convert:

• Kelvin (K) to Celsius (C) or Fahrenheit (F) (using GTemperatureUnit)
• "%" to "‰" (using GPercentUnit).

Return to the introduction ↑ Go to the next page →